Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
A ceiling fan there
05-17-2018, 11:55 PM
Post: #1
Big Grin A ceiling fan there
So Im sitting in the kitchen in the center of your day getting ready to watch a football game, I have the range going with the little hotdogs, getting ready to settle in when it happened...Im perspiration!

Thats when I decided to put in a ceiling fan. A ceiling fan provides several useful benefits while adding a certain decorative effect to your area. In the summertime it will also help cool a space (or possibly a deck). In the winter it may be used at low rates to distribute warmer air that has increased to roof level.

Whatever your reason behind installing a ceiling fan, you'll find it to be a comparatively easy task especially if you'll be replacing a light fixture in the middle of a space (all the wiring will already be there). Probably your biggest obstacle would have been a new workbox that is approved for the weight of an overhead fan or adding support to an existing workbox, a workbox that's perhaps not approved for limit fan weight can cause disaster!

General installations are covered by the following instructions when changing a current light. It will give a concept to you of what is necessary for the task. Ensure you evaluate and follow instructions that are unique to the fan you buy. Based on your installation requirements, you will need to purchase a lengthier down rod for cathedral ceilings or if it is not included purchase an optional light equipment.

1) Turn off the signal by switching off the breaker. Remove the existing ceiling fixture. To learn additional info, consider having a look at: privacy.

2) Determine if enough support will be provided by your existing workbox. Check to see if the workbox has steel mix braces that span between two joists, if you have use of the workbox from your own basement. If not, you are able to cut a 2x4 to match in-between the joists. Deploy it so it touches the top of the workbox. Anchor the wood in place. From the place, use 1 drywall screws to anchor the box to the wood brace.

3) If you do not have access from the attic, you can put in a metal cross brace through the rough opening in your ceiling and then connect an approved workbox towards the metal brace. If you know any thing, you will maybe claim to compare about jump button.

4) I hate this part! Assemble the ceiling fan based on the manufacturers provided recommendations. When you are ready to hold the lover, take the mounting bracket and install it towards the limit workbox. Some fans come with a hanging frame that enables you to catch the ball end-of the pole in-place. Others have a group that provides a T lift that enables you to hang the motor housing while hooking up the wiring

5) most likely the present wiring provides one, In the event that you removed a light fixture in the ceiling turned signal for your new ceiling fan. This means the wall switch will function as master switch to show the unit off and o-n. To discover more, consider peeping at: recessed can light led replacement. The pull string about the fan will also control the fan (and its speed). A pull chain and both the wall switch may also get a grip on it, If you install an optional light kit on the lover.

6) Following wiring diagram provided with the fan, hook up the wires using wire nuts. Most likely this is as easy as connecting the 2 black wires; connecting the 2 white wires and connecting the 2 ground wires.

7) When the fan is sent, finish its construction according to the particular manufacturers guidelines. You will have to deploy the canopy to the top-of the pole.

8 )You will even need to connect the fan blades. Remove the cover on the bottom of the fan where the light kit is going to be installed, If you are adding a light kit. Following a manufacturers directions, assemble and install the light kit.

At this point you're prepared to start enjoying your ceiling fan and switch the breaker on..
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)